We have an essential info section looking at how to ID chains – why not take a look by clicking here.

Chains are not measured by stretching them out on a bench and squinting down a tape measure – chains are identified by PITCH, GUAGE and NUMBER OF DRIVE LINKS [no – not the cutting teeth – drive links and you’ll know the difference by even a cursory look at the chain ID link above].

Bars likewise are not measured the same way – manufacturers give them a set ‘length’ which is generally the sticky out bit that comes out of the chainsaw [not including the mount unless in the case of large double ended milling bars which are the exception to the rule and measured end to end].

Chain sharpening is key – if you cannot use a chain and have it cutting well until the cutters are so small they end up getting knocked off – you have plenty to learn. Watch, research, rinse and repeat. Read our article on chain sharpening by clicking here – often people get caught up in different angles and techniques – but the principles are always the same.

If you are serious about correct maintenance of your bar and chain work your way through the Oregon manual [click here] and after that check out the Stihl equivalent [click here]. Using a chainsaw for 20 years [badly] does not qualify you as an experienced user – so be the change, make the difference and keep educating yourself about these valuable yet dangerous tools.

And finally – why buy a new bar and chain without checking/replacing the drive rim or drive sprocket? [again click here if unsure on what these refer to]. Would you change the oil on your car without changing the oil filter?


P-3/8LP-050-FSR Panther Lo Pro Full Skip Ripping Chain 3/8 Lo Pro .050[1.3mm]

$0.51

Add to
Stock 27053
Part Number P-3/8LP-050-FSR Part Number P-3/8LP-050-FSR Categories: ,

Please make sure you order the correct number of drive links for your bar Check you have not just ordered 1 drive link

 


New Panther 3/8 Lo Pro Full Skip Ripping Chain. For the longer bars and/or smaller saws where the bar is over length. No need to use this if you have a good power to bar length ratio and it will likely cut slower. This will work well on the GB Lo Pro bars and on other applications where you need a lo pro ripping chain. Same type of chain as Oregon 91R and Stihl 3614-63PMX [But in a full skip formation].


 

  • P stands for Panther
  • 3/8LP = self explanatory – it is 3/8 Lo Pro chain
  • 050 = gauge of chain is .050[1.3mm]
  • FSR = Full Skip Ripping
Translate »

Orders for United States of America must be a minimum of $120.

Please ensure your cart total exceeds this before checkout. We need to sell a certain value per order to cover shipping cost. Please try and group your orders together rather than little and often. Thanks from the Chainsawbars Team.