We have an essential info section looking at how to ID chains – why not take a look by clicking here.

Chains are not measured by stretching them out on a bench and squinting down a tape measure – chains are identified by PITCH, GUAGE and NUMBER OF DRIVE LINKS [no – not the cutting teeth – drive links and you’ll know the difference by even a cursory look at the chain ID link above].

Bars likewise are not measured the same way – manufacturers give them a set ‘length’ which is generally the sticky out bit that comes out of the chainsaw [not including the mount unless in the case of large double ended milling bars which are the exception to the rule and measured end to end].

Chain sharpening is key – if you cannot use a chain and have it cutting well until the cutters are so small they end up getting knocked off – you have plenty to learn. Watch, research, rinse and repeat. Read our article on chain sharpening by clicking here – often people get caught up in different angles and techniques – but the principles are always the same.

If you are serious about correct maintenance of your bar and chain work your way through the Oregon manual [click here] and after that check out the Stihl equivalent [click here]. Using a chainsaw for 20 years [badly] does not qualify you as an experienced user – so be the change, make the difference and keep educating yourself about these valuable yet dangerous tools.

And finally – why buy a new bar and chain without checking/replacing the drive rim or drive sprocket? [again click here if unsure on what these refer to]. Would you change the oil on your car without changing the oil filter?


3661-13RMS Stihl Carving Micro Chisel 1/4 .050[1.3mm]

$0.52

Add to
Stock 1987
Part Number 3661-13RMS Part Number 3661-13RMS Category:

Please make sure you order the correct number of drive links for your bar Check you have not just ordered 1 drive link

 


Stihl 3661-13RMS is pretty much the only dedicated carving chain on the market. Low-vibration comfort sawing with excellent cutting performance. Short cutter top plate eliminates the need to press down when boring. Achieves noticeably better boring speeds in comparison to conventional 1/4″ saw chains. Ideal for wood carvers and arborists. But it also functions well for general cutting.


 

Customer Reviews

Based on 11 reviews
91%
(10)
0%
(0)
0%
(0)
0%
(0)
9%
(1)
J
Jonathan Wisbey

It's the wrong pitch totally fault for ordering I need the 1/4 inch pitch one 60 drive links. Could some one get in contact regards returning it please. My email address is [****]

R
Rob Dalton
Great

This is the chain I use on my most used carving chainsaw. They’re a great chain.

J
Johan Sandström

3661-13RMS Stihl Carving Micro Chisel 1/4 .050

C
Christopher Wood

3661-13RMS Stihl Carving Micro Chisel 1/4 .050

R
Robert Dalton

Great

Translate »

Orders for United States of America must be a minimum of $120.

Please ensure your cart total exceeds this before checkout. We need to sell a certain value per order to cover shipping cost. Please try and group your orders together rather than little and often. Thanks from the Chainsawbars Team.