We have an essential info section looking at how to ID chains – why not take a look by clicking here.
Chains are not measured by stretching them out on a bench and squinting down a tape measure – chains are identified by PITCH, GUAGE and NUMBER OF DRIVE LINKS [no – not the cutting teeth – drive links and you’ll know the difference by even a cursory look at the chain ID link above].
Bars likewise are not measured the same way – manufacturers give them a set ‘length’ which is generally the sticky out bit that comes out of the chainsaw [not including the mount unless in the case of large double ended milling bars which are the exception to the rule and measured end to end].
Chain sharpening is key – if you cannot use a chain and have it cutting well until the cutters are so small they end up getting knocked off – you have plenty to learn. Watch, research, rinse and repeat. Read our article on chain sharpening by clicking here – often people get caught up in different angles and techniques – but the principles are always the same.
If you are serious about correct maintenance of your bar and chain work your way through the Oregon manual [click here] and after that check out the Stihl equivalent [click here]. Using a chainsaw for 20 years [badly] does not qualify you as an experienced user – so be the change, make the difference and keep educating yourself about these valuable yet dangerous tools.
And finally – why buy a new bar and chain without checking/replacing the drive rim or drive sprocket? [again click here if unsure on what these refer to]. Would you change the oil on your car without changing the oil filter?
21BPX Oregon Micro Chisel .325 .058[1.5mm]
59L Oregon Full Chisel .404 .063[1.6mm]Part Number 59L2 reviewsStock 2720
3668-46RM Stihl Micro Chisel .404 .063[1.6mm]Part Number 3668-46RMStock 5271
M73LPX Oregon Chisel Multicut 3/8 .058[1.5mm]Part Number M73LPX2 reviewsStock 295
3621-36RS Stihl Chisel 3/8 .063[1.6mm]Part Number 3621-36RS13 reviews